Inserting Program Outputs in an OR Structure
You can insert a program output in an OR structure.
Method 1/ Using the O Key
Select the output where you want to insert the OR output in the Ladder Editor and press the O Key.
Method 2/ Selecting from the Right-Click Menu
Right-click the output where you want to insert the OR output and select [Insert Parallel Output Below] from the menu.
Method 3/ Dragging
Drag the connecting line from the start point where you want to insert the output to the right bus bar at the end point.
Select [Output] from the pop-up menu.
Method 4/ Using the Ctrl + Right Arrow Keys
Select the start point where you want to insert the output, hold down the Ctrl Key and press the Right Arrow Key twice, and then release the Ctrl Key.
Select [Output] from the pop-up menu.
Video search results for "Operation Manual Video"
Search results are 0. ¶Please run the search again.
A total of xx results were retrieved.
Search for " xx "
Questionnaire about Syamac Studio
Please fill out this survey to help us improve the quality of Syamac Studio.
Answer
There is no page.
In prepararion