Adding Connecting Lines
You can add connecting lines in the ladder editor.
Method 1/ Displaying the Ladder Guide
Press the T key at the position where you want to add a connecting line and press the numeric key for the position number to which to connect the line. Then, press the shortcut key for the circuit part to add.
Method 2/ Selecting from the Right-Click Menu
Right-click at the position where you want to add a connecting line and select [Add Connecting line]. Press the numeric key for the position number to which to connect the line. Then, press the shortcut key for the circuit part to add.
Method 3/ Dragging
Drag a connecting line from the start point to end point. A pop-up menu is displayed. Select the circuit part to add.
Video search results for "Operation Manual Video"
Search results are 0. ¶Please run the search again.
A total of xx results were retrieved.
Search for " xx "
Questionnaire about Syamac Studio
Please fill out this survey to help us improve the quality of Syamac Studio.
Answer
There is no page.
In prepararion